·         Install new safety decals where needed, replace snow shield if needed (Shield extra charge if needed)

·         Replace vertical and horizontal conveyor bearings, inspect conveyors for visual damage and straightness

·         Replace all replaceable lift arm bolts and bushings, check lift arm for wear and straightness

·         Replace / or supply new spreader towel and squeegee

·         Inspect conditioner for wear in critical areas

·         Engine tune-up; includes compression test, air filter, plugs, points (if used), cap, and rotor. (Any additional tune-up parts are extra).

·         Replace LP fuel regulator, inspect LP fuel lock off and rebuild if required. (Parts extra) All models except 540

·         Check oxygen sensor for proper operation on units so equipped. Replace if needed. (Part extra)

·         Exhaust emission test and adjust

·         Check charging system, check battery condition (load test), clean battery cable connections

·         Change engine oil and filter

·         Lube all chassis grease zerks with factory recommended grease

·         Change fluid in differentials and gear box with factory recommended fluid

·         Visually inspect differential ring and pinion gears for wear or damage

·         Remove and inspect front and rear drive axles for wear, inspect front drive axle joints for wear

·         Inspect, clean, and repack front and rear wheel bearings, replace bearings when needed. (Parts additional)

·         Inspect tires for worn / missing studs or visible damage to tire casing

·         Inflate tires to recommended specifications  (Zamboni Co. specs)

·         Inspect transfer case, gear box, and hydraulic cylinders for seepage

·         Replace hydraulic filters, remove and clean washable filters

·         Test hydraulic pumps for proper flow and pressure

·         Visually inspect hydraulic pressure and return hoses for seepage and damage

·         Remove, filter, and reinstall hydraulic fluid, replace if needed (Fluid additional)

·         Remove hydro pump, inspect drive plate and pump shaft for wear or damage

·         Remove hydro drive motor, inspect motor for worn shaft, inspect gear box for worn input gear (500/520/540)

·         (552 only) Capacity test battery system, acid adjustment is additional if required

·         (552 only) Inspect traction motor and hydraulic pump brushes for wear

Upon completion of this program R&R Specialties, Inc will advise you of any Additional Costs
for repairs or updates that your machine may need to bring the unit up to factory specifications.